Silicone paint Cover Sil (base TR)

• Protects the surface from water, moss.
• It has good vapor permeability.
• Prevents the removal of salts from the surface.

• Indoor and outdoor work

Surface Preparation:
To ensure reliable adhesion of the product, the surface must be clean, dry and free from defects such as sticky materials, dust, grease, oil, rust, moss, steam, etc. Apply the recommended primer coat (primer, waterproofing coat, putty) on new or porous surfaces. Mix the product well and apply in two coats. The product reaches full resistance to mechanical loads after 20-30 days.
Application conditions:
Do not apply at temperatures below 6°C and above 40°C with relative humidity above 80%. Adverse conditions of use may alter the quality characteristics of the product.

Keep tools in container while working in "wet" condition. Completely clean the tool from the paint and drain it back into the container, then wash the tool with warm water and soap. If the product (paint) dries, clean it off with a strong detergent only. Do not allow the used water to enter the ground water.

Safety regulations:
Keep out of reach of children. Avoid contact with skin and/or eyes. In case of contact with eyes, rinse immediately with running water and consult a doctor if necessary. If swallowed, seek medical advice immediately. The workplace must be well ventilated. Wear personal protective equipment during application. The VOC content of 40 g/l complies with the European Union requirements for this product.
Waste management:
In order not to pollute the environment, production waste must be specially treated. Therefore, do not dispose of together with household waste. Contact local authorities for more information on waste collection and disposal.
Storage:
Close the container tightly after use to save it for later use. Store in a cool place. Protect from freezing and direct sunlight.

EL.OT*7.88" refers to the characteristics of the paint and is part of the Greek standard by which the characteristics of the paint are determined.